Press fleeceOptimal protection against fractures and tears

Profit from fast, simple production processes with our press fleece with a glue coating on one side. The fleece is precisely adhered to the veneer by heating up the glue coating in the press with no additional glue required. This saves time and reduces further running costs.
Thanks to the adhesive precoating, applied as an aqueous system, the bond is extremely resistant to heat and water if the pressing temperature and corresponding pressure are sufficient. In combination with the sealed glue surface, which prevents penetration by fluids and solvents, veneer-reinforcement fleece provides optimal protection against fractures and tears during further processing.

Properties

  • High reinforcing effect with high flexibility
  • Increase in productivity due to shorter pressing times
  • Good adhesiveness on the reverse side of the backing
  • Available in different colours and widths   
available width from 1,250 to 1,500 mm depending on type Cutting possible
Production width 1.240 mm, 1.500 mm
Adhesive layer applied Both-sided
density Approx. 150 µm
Pressing temperature 140°C ideal, min. 120°C
available colors cream
available width from 1,250 to 1,500 mm depending on type Cutting possible
Production width 1.270 mm, 1.550 mm
Adhesive layer applied One-sided
density Approx. 300 µm
Pressing temperature 140°C ideal, min. 120°C
available colors white, beige, brown
Adhesive layer applied One-sided
density Approx. 120 µm
Production width 1.250 mm, 1.515 mm
Pressing temperature 140°C ideal, min. 120°C
available width from 1,250 to 1,500 mm depending on type Cutting possible
available colors cream